I second this. I run an A1 on a separate IoT wifi network that doesn't have outbound connectivity and using nftables rules for forwarding can send prints from my normal network with minimal fuss.
I did have to play around and use orcaslicer to get the printer set up using the network printing and camera feed working.
The one issue I do have is that it seems I would need to connect the printer to a internet enabled Network to get firmware updates, because the firmware version I have is ironically the one before they enabled SD card updating lol.
Back to the original question, I've had this printer for about a month and have been printing virtually non-stop with very minimal complaints. Coming from an ender 3 it is absolutely night and day in terms of ease of setup and general usage.
Good to find the bug regardless! I appreciated the succinct and not overly dramatic write-up. I don't think anything significant was claimed other than the fact that it is a kernel bug (which is significant in itself don't get me wrong).
I did have to play around and use orcaslicer to get the printer set up using the network printing and camera feed working.
The one issue I do have is that it seems I would need to connect the printer to a internet enabled Network to get firmware updates, because the firmware version I have is ironically the one before they enabled SD card updating lol.
Back to the original question, I've had this printer for about a month and have been printing virtually non-stop with very minimal complaints. Coming from an ender 3 it is absolutely night and day in terms of ease of setup and general usage.