I'm on Mounjaro for T2D, previously on Ozempic. Besides the weight loss and the blood sugar control it also eliminated my IBS as well. Before the drug certain foods, especially nuts would cause excruciating digestive issues. I can now eat them without worry. It's been amazing.
I think it's doable with a parametric design in Fusion but it is definitely more work up-front or re-work after you have a working version. Getting a well parameterized and set of constrained sketches can be a time consuming process since I don't do it every day. It's probably the part I've struggled with the most in making 3D printable designs (I'm not OP but design cosplay props for my kids) since I don't always know what I want the final dimensions to be.
We just completed the switch to Rancher where I work. 1200ish engineers, mostly on Macs. So far it's worked out pretty well..fewer hiccups than I expected.
This may be a terminology thing but as a T2 I will always carry that diagnosis. However, mine is in remission because I manage it through medication/diet.
My doctor and I have talked about trying to see if I can drop the medications and still stay in remission but I'll still be a T2 patient.
Also, not all T2s can manage just through a ketogenic diet.
I think it's only going to get worse as the LLMs get just that much better that people stop thinking more critically about what they generate. Right now I think many people still verify or read through the results to make sure they sound right. What happens when people get lulled into complacency and then it really goes off on a bender.
From my limited vantage point (in-laws) this is normal in the Filipino culture. My wife and I moved away from her parents so we didn't do this but her sister's kids were probably a 70/30 split in being at the grandparents' house. Her cousin's kids were the same. In fact, many of them would send the kids to the Philippines for months at a time where the grandparents lived to be raised by them. It felt really odd to me at first but that's more because it wasn't how I was raised plus I didn't have any grandparents that were still alive when I grew up.
This could almost be me. The main difference is my "server" is an off-lease Dell Micro PC that I maxed out the RAM on running ProxMox with a mix of VMs with everything stored on a Synology NAS all sitting in my basement office closet. I have tailscale setup so I can access it remotely.
While I do use the AMS for multi-color prints, it's actually more useful to me because I can keep four filaments loaded at any time and it's easier to swap filaments out of the AMS that from behind the printer. I try to avoid prints with a ton of color changes just because of how much it slows down prints and the amount of waste it generates.
If the Prusa XL wasn't so expensive for 5 toolheads I'd get that since its' much faster for filament switches and the minimal amount of waste it generates.